• Home
• Get a Quote
• Blog

After a period of time, the protective finish of a hardwood floor may wear off; get in touch with Waterford hardwood floor refinishing companies for applying a new finish at affordable rates. Sanding the floor before a refinishing process can create a lot of dust; these experts are well trained in refinishing these floors using vacuum systems that will hardly cause any dust to be airborne. The floor is ready for use within hours of refinishing.

If you are not sure about the type of finish you require for your hardwood floor, consult Waterford hardwood floor refinishing services for ideas and suggestions. It is recommended that a fresh coat of finish is applied every two years or if the surface looks worn out and dull. Though oil-based finishes are cheaper, only water-based ones last longer; these professionals will test new products in a small area first, and then apply it using the right techniques allowing appropriate drying time between coats.

If you are not too sure about replacing your worn out hardwood floor with a new installation, consult Waterford hardwood floor refinishing services to check if refinishing can restore its glossy looks. Brand new floors can be very expensive; these professionals will inspect your floor and recommend repair if necessary. After the holes, gaps, crevices and cracks are evened out and the surface is smoothened using appropriate techniques, these experts will refinish the floor using water or oil based finishes to give your floor a brand new look.

Using the right type of sanding machines and tools will level an uneven hardwood floor more effectively; only Waterford hardwood floor refinishing companies can choose the correct grit to sand your floor. Following all the procedures in the correct sequence will make sure that effective refinishing is achieved even on uneven, scratched, rough and bare wooden floors. These experts use modern machines that can refinish the floor even without going through the sanding procedures; they will also make sure that the surface is cleaned thoroughly before commencing the process.